|
Insteon Input/Output Interface Module |
|
|
EZIO8T is a module that allows inputs and outputs from external devices to be
connected to Insteon and X10 networks at the point of need. External
events such as contact closures can be detected or monitored via three inputs.
One of the inputs can
be programmed as a 1-Wire bus such that it can be used to connect sensors
compatible with this protocol.
Out of the box, the unit interfaces with the Dallas Semiconductor 18B20
temperature sensor. The inputs can trigger an Insteon group command to cause any
activity by a responder in the network. Eight outputs driven by triacs
(solid-state relays) can be used to
control small AC loads such as low voltage outdoor lights and railroad models.
|
Now you can control and monitor anything in your Insteon/X10
home automation network with your EZIO8T!
|
|
EZIO8T Features:
- Simple and rapid installation
- Puts home automation inputs and outputs where you need it, eliminating
wiring nightmares.
- Three general purpose inputs (combinations of all digital level
(0-5VDC), or digital and the Dallas Semiconductor 1-Wire bus)
- Eight general purpose, Triac driven AC outputs (rated at 500mA and 48
VAC).
- Device can act as an Insteon sender with each of the 3 inputs able to
trigger a unique group on/off command
- Responds to Insteon and X10 commands to turn on or off each or any
combination of the 8 outputs.
- Extensive command set for maximum programming flexibility
- Acts as a repeater of powerline INSTEON signals
- 2-way communications for high reliability
- Pass-through outlet may be used for other
appliances
- 1-year warranty by Simplehomenet
|
|
